FFF Printer Tuning for Accuracy

From Double Jump Electric Wiki
Revision as of 00:51, 23 September 2019 by Poofjunior (talk | contribs) (Perimeter Ordering)
Jump to navigation Jump to search

By accounting for a variety of factors that affect the accuracy of our printing process, we can dial in our 3D printers to get a fairly sufficient level of accuracy for functional, mechanical prototypes. Here's a breakdown of the factors to tune.

Extrusion Width

Even though nozzles come in fixed sizes, the resulting extruded line is almost always slightly thicker after it has been deposited onto the forming part. This happens for a variety of reasons. But the main reason is that each subsequent layer is squished onto the prior layer with some overlap to ensure that the two layers fuse. Accounting for this thickness is key to getting accurate feature sizes, especially for small holes.

Measuring Extrusion Width

We can measure extrusion width from a flat surface of a single-layer thick wall. To create such a test object, simply print a cube with an open top in vase mode. From here, measure the wall with a pair of calipers.

measuring extrusion width from an object printed in vase mode

Accounting for Extrusion Width

Most slicers actually have a setting for extrusion width. Simply input your measured value.


Perimeter Ordering

For tighter-tolerances, print the outermost perimeter first, followed by the inner perimeters. Doing so yields tighter tolerance features (esp: holes) that printing innnermost-to-outermost. The reason why has to do with what's happening to the filament as it is being deposited. When printing any adjacent perimeters, imagine that the first perimeter wall is cooler and more solid than the second perimeter wall. As the second perimeter is printed with some slight overlap with the first, it is effectively "rolling" off of the original perimeter. The original perimeter is cooler and more solid, so it doesn't move as a result of the new perimeter overlapping it. The current perimeter being deposited, however, is still melted and does shift slightly as it rolls off the prior perimeter.

The most-obvious symptom of printing innermost-to-outermost is that parts will seem to be slightly too small no matter what settings you tweak.